异步DS-CDMA系统中基于矩阵点除算法的DOA估计

针对异步DS-CDMA系统中的多用户环境,本文提出了一种低复杂度的DOA估计算法——矩阵点除算法。该算法通过对感兴趣信息的逐次分离,实现了DOA的逐路径估计。算法具有两方面显著优势:(1)克服了传统的DOA估计算法在路径总数大于天线阵元数时不能工作这一缺陷:(2)避免了计算复杂的特征值分解运算,大大降低了算法复杂度。仿真实验验证了算法的有效性。     

基于EDGE系统信道估计实现方案的研究

研究了基于ＥＤＧＥ系统接收机中信道估计的实现方案，并对算法的各项性能做出评估。首先论述了算法的采用及其理论依据。接着，说明了信道预估计的原理及方法。最后，针对ＭＡＴ－ＬＡＢ及 ＤＳＰ上的仿真结果，比较了各项系数对于系统性能改善所具有的影响和作用，对系统特性作了较为详细的分析总结。     

Outlier-resistant methods for estimation and model fitting

Least squares is perhaps the most widely used technique for model fitting. In this article, we illustrate the poor performance of least squares when there are spurious values, or outliers, in a sequence of measurements. A brief overview of three well-known classes of robust alternatives to the least-squares mean is presented. For robust regression, a recent proposal called least median squares (LMS) is decribed. LMS regression is compared to least-squares regression in an example involving the estimation of optical fiber geometry. References are provided for software that is available for robust estimation techniques surveyed in this article.     

GaN and AlGaN high-voltage rectifiers grown by metal-organic chemical-vapor deposition

In this paper, we report the study of the electrical characteristics of GaN and AlGaN vertical p-i-n junctions and Schottky rectifiers grown on both sapphire and SiC substrates by metal-organic chemical-vapor deposition. For GaN p-i-n rectifiers grown on SiC with a relatively thin “i” region of 2 μm, a breakdown voltage over 400 V, and forward voltage as low as 4.5 V at 100 A/cm² are exhibited for a 60-μm-diameter device. A GaN Schottky diode with a 2-μm-thick undoped layer exhibits a blocking voltage in excess of ∼230 V at a reverse-leakage current density below 1 mA/cm², and a forward-voltage drop of 3.5 V at a current density of 100 A/cm². It has been found that with the same device structure and process approach, the leakage current of a device grown on a SiC substrate is much lower than a device grown on a sapphire substrate. The use of Mg ion implantation for p-guard rings as planar-edge terminations in mesageometry GaN Schottky rectifiers has also been studied.     

相干源二维波达方向估计

本文分析了平面阵接收信号的协方差矩阵，发现它可分解为一个广义对称矩阵与一个非广义对称矩阵之和，利用信号协方差矩阵的这一结构特征，重点研究了相干源二维波达方向（DOA）估计．该方法通过构造一个差矩阵，求出其本特征值对应的任一特征向量，利用谱函数估计相干源二维DOA．简要分析了二维DOA估计的分维处理。     

心电地图仪中工频干扰的一种滤除方法

在心电地图仪中记录到的体表心电信号往往由于电磁的影响而引进工频干扰．基于体表心电信号中工频干扰的特点，作者提出了一种滤除工频干扰的方法，即就单独—胸导联信号通过提高频谱的分辨率来估计工频干扰的频率；基于最小均方误差准则来估计各导联信号中工频干扰的幅度和相位。文中还给出了该算法的流程图和滤波性能分析。模拟结果表明了该算法的有效性。应用该算法对心电地图仪中的工频干扰进行对消，取得了满意的结果。     

Neural networks for nonlinear state estimation

Estimating the state of a nonlinear stochastic system (observed through a nonlinear noisy measurement channel) has been the goal of considerable research to solve both filtering and control problems. In this paper, an original approach to the solution of the optimal state estimation problem by means of neural networks is proposed, which consists in constraining the state estimator to take on the structure of a multilayer feedforward network. Both non-recursive and recursive estimation schemes are considered, which enable one to reduce the original functional problem to a nonlinear programming one. As this reduction entails approximations for the optimal estimation strategy, quantitative results on the accuracy of such approximations are reported. Simulation results confirm the effectiveness of the proposed method.     

存在噪声和未建模动态系统传递函数的渐近无偏估计

存在未建模动态时，如何去除系统传递函数估计中噪声引起的偏差是系统辨识关心的重要问题。本文将我们已提出的ＢＥＬＳ方法进行推广得出：当系统未建模动态可用－ＦＩＲ模型描述时，应用本文的方法可得到系统传递函数的无偏辨识，而不需知道有关噪声和未建模动态概率分布函数的先验知识。     

Parameter and state estimation of the activated sludge process-II. Applications

In a companion article (Kabouris and Georgakakos, 1996) the Linearized Maximum Likelihood (LML) method for the simultaneous estimation of activated sludge process states and parameters from noisy process measurements is presented. The present article describes the application of the LML method to the identification of a nitrifying activated sludge process, modelled by the IAWPRC Activated Sludge Model 1. It is concluded that identification of nine of the model parameters from process measurements is only possible when a sequential estimation scheme is applied and only influential measurements are considered.     

加强项目前期工程造价管理的主要措施

介绍了工程造价管理的定义、特点、内容及对象。阐述了项目前期工程造价管理的重要性 ,并就目前项目前期工程造价管理中投资估算编制存在的问题 ,提出了几点建议